User guide

Publication 1746-UM006B-EN-P - August 2005

4-22 Configuration and Programming

I:e.4 Bits 0 through 7 - Configuration Error Code

I:e.4 Bits 8 through 15 - Output Status

These bits reflect the current state of both the Soft and Physical

Outputs. If the Enable Output bit (M0:e.1/1) is false or if the processor

is not in run mode, the Physical Outputs are not active.

Bits 8-11 represent the Physical Outputs 0-3. Bits 12-15 represent the

Soft Outputs 4-7.

I:e.5 Reserved

Configuration

Error Code

Reason Critical

Error

Action

Hex Binary

01 0000 0001 not defined -

reconfigure

(1)

(1) The Function Control bit must be reset to 0, the parameter must be changed, and the Function Control bit is

then set to 1

02 0000 0010 max count = 0 (ring) yes

reconfigure

(1)

03 0000 0011 invalid operating mode yes

reconfigure

(1)

04 0000 0100 invalid input type yes

reconfigure

(1)

05 0000 0101 static parameter changed yes

reconfigure

(1)

06 0000 0110 ranges active = 0 no change parameter

07 0000 0111 rate period = 0 no change parameter

08 0000 1000 linear counter reset value out of range no change parameter

09 0000 1001 sequencer preset > max. count no change parameter