User guide

Publication 1746-UM006B-EN-P - August 2005
E-2 Sequencer Mode Configuration Worksheets
Setup and Control Word (page 4-25)
Valid Steps (page 4-31)
Initial Output (page 4-32)
ATTENTION
The module will fault on power-up if you do not
enter a value.
Counter Type (page 4-31)
Function Control (page 4-30)
Soft Reset (page 4-27)
Sequencer Reset (page 4-26)
Operating Mode (page 4-31)
Input Type (page 4-29)
Reset Mode (page 4-28)
Up/Down Count Direction (page 4-27)
Enable Outputs (page 4-26)
Counter Hold (page 4-27)
ATTENTION
The module will fault on power-up if you do not
enter a value.
M0:e.2
765 432 1 0Bit Number (decimal) 15 14 13 12 11 10 9 8
7654321Step Number 15 14 13 12 11 10 9 8
M0:e.3
Valid Steps 1 – 16
Initial Outputs and Valid Steps 17 – 24
1 = Valid Step. At least one preset must be valid.
16
765 432 1 0Bit Number (decimal) 15 14 13 12 11 10 9 8
M0:e.3
Initial Outputs and Valid Steps 17 – 24
The Initial Output is the output pattern’s starting position