User guide

1 Publication 1746-UM006B-EN-P - August 2005

Appendix

Sequencer Mode Configuration Worksheets

Shown below is the Sequencer Mode Configuration Worksheet for the

Output and M0 File.

Output and M0 File

Worksheets

Direct Outputs (page 4-36)

Output Source Select (page 4-24)

ATTENTION

The module will fault on power-up if you do not

enter values for the Setup and Control Word, Valid

Steps, Rate Period, and Reset Value/Maximum Count

Value.

RRRRRRRR

O:e.0

Direct Outputs

1 = output ON if under processor control

765 432 1 0

765 4321 0

Bit Number (decimal)

Output Number

15 14 13 12 11 10 9 8

Bits 0 thru 3 relate to Physical Outputs

Bits 4 thru 7 relate to Soft Outputs

M0:e.0

765 432 1 0Bit Number (decimal) 15 14 13 12 11 10 9 8

1 = processor 0 = Module

Output Source Select

RRRRRRRR

Bits 0 thru 3 relate to Physical Outputs

Bits 4 thru 7 relate to Soft Outputs

= Reserved, must be reset to 0