Owner's manual

1 Publication 1746-RM001A-US-P

Chapter

Execution Control and Interrupt Support

Functions

This chapter describes and illustrates commands that control data flow and

program transfer between ROM and RAM within the BASIC program or from the

command line. Table 8.1 lists the corresponding mnemonics.

Table 8.1 Chapter Reference Guide

If you need (to) Use this

mnemonic

Page

Enable the interrupt capability when a DF1 packet is received. CALL 16 8-2

Disable the DF1 packet interrupt capability. CALL 17 8-3

Enable the SLC processor interrupt capability. CALL 20 8-3

Disable the SLC processor interrupt capability. CALL 21 8-4

Generate an interrupt to the SLC processor. CALL 26 8-4

Initiate transactions defined by CALLs 27, 28, 122, and 123. CALL 38 8-5

ROM to RAM program transfer CALL 70 8-8

ROM/RAM to ROM program transfer CALL 71 8-9

RAM/ROM return CALL 72 8-9

Execute a subroutine. GOSUB 8-11

Go to line number when an error is detected. ONERR 8-12

Conditional GOSUB ON-GOSUB 8-14

Generate an interrupt when TIME is equal to or greater than

ONTIME argument-line number.

ONTIME 8-14

POP argument stack to variables. POP 8-17

PUSH expressions on argument stack. PUSH 8-15

Return from interrupt. RETI 8-18

RETURN from subroutine. RETURN 8-18

Break program execution. STOP 8-20