Owner's manual

Publication 1746-RM001A-US-P

BASIC Commands 4-13

Syntax

MODE(port name, baud rate, arg1, arg2, arg3, arg4, arg5)

Table 4.3 PRT1 and PRT2 Port Parameters

Port Parameters Selections Default Settings

baud rate 300, 600, 1200, 2400, 4800, 9600, 19200 1200

arg1 (parity) None (N), Even (E), Odd (O) N

arg2 (number of data bits) 7 or 8 8

arg3 (number of stop bits) 1 or 2 1

arg4 (handshaking) No handshaking (N)

Software handshaking (S)

Hardware handshaking (H)

Hardware and software handshaking (B)

arg5 (storage type) Store information in user ROM and RAM (E)

Store information in battery backed RAM (R)

IMPORTANT

If any argument (other than port name and baud rate) is left

blank, then that argument defaults to the previously specified

value for that argument.

Table 4.4 DH485 Port Parameters

Port Parameters Selections Default

Settings

baud rate 300, 600, 1200, 2400, 4800, 9600, 19200 19200

arg1 (host node address) 0 to 31 0

arg2 (module node address) 0 to 31 1

arg3 (maximum node address) 1 to 31 31

arg4 (not used)

arg5 (storage type) Store information in user ROM and RAM (E)

Store information in battery backed RAM (R)

IMPORTANT

If any argument (other than port name) is left blank, then that

argument defaults to the previously specified value for that

argument.