Owner's manual

Publication 1746-RM001A-US-P
BASIC Command, Statement, and CALL Quick Reference Guide B-5
CALL 90 PUSH [remote device node address]
PUSH [remote device file number]
PUSH [remote device file type]
PUSH [starting element offset (x2) of remote
device file]
PUSH [number of elements to be transferred]
PUSH [message time-out value]
POP [status of message instruction]
Read remote DH485 data file to BASIC input
buffer.
13-20
CALL 91 PUSH [remote device node address]
PUSH [remote device file number]
PUSH [remote device file type]
PUSH [starting element offset (x2) of remote
device file]
PUSH [number of elements to be transferred]
PUSH [message time-out value]
POP [status of message instruction]
Write module output buffer to remote DH485
data file.
12-18
CALL 92 PUSH [remote device node address]
PUSH [starting element offset (x2) of remote
device file]
PUSH [number of words to be transferred]
PUSH [message time-out value]
POP [status of message instruction]
Read remote DH485 interface file to module
input buffer.
13-23
CALL 93 PUSH [remote device node address]
PUSH [starting element offset (x2) of remote
device file]
PUSH [number of words to be transferred]
PUSH [message time-out value]
POP [status of message instruction]
Write module output buffer to remote DH485
interface file.
12-22
CALL 94 None Print current PRT1 port setup. 12-24
CALL 95 PUSH [buffer selection]
POP [number of characters]
Get number of characters in PRT1 buffers. 11-10
CALL 96 PUSH [buffer selection] Clear port PRT1 input and output buffers. 12-24
CALL 97 None Enable port PRT2 DTR signal. 11-11
CALL 98 None Disable port PRT2 DTR signal. 11-11
CALL 99 None Reset print head pointer. 14-3
CALL 101 PUSH [starting address]
PUSH [ending address]
Upload user memory module code to host. 5-4
CALL 103 None Print port PRT1 output buffer and pointer. 5-5
CALL 104 None Print port PRT1 input buffer and pointer. 5-6
CALL 105 None Reset port PRT1 to default settings. 14-4
Mnemonic Required PUSHes or POPs Description Active In
Command
Mode
Only
Page