Owner's manual

Publication 1746-RM001A-US-P
B-2 BASIC Command, Statement, and CALL Quick Reference Guide
CALL 24 PUSH [value to be converted]
PUSH [word number of module output
buffer]
BASIC floating-point to 16-bit signed integer 9-2
CALL 25 PUSH [value to be converted]
PUSH [word number of module output
buffer]
BASIC floating-point to 16-bit binary 9-3
CALL 26 POP[ SLC processor status] Generate an interrupt to the SLC processor. 8-4
CALL 27 PUSH [type of READ command]
PUSH [remote node address]
PUSH [remote file number]
PUSH [remote file type]
PUSH [starting word offset of remote file]
PUSH [number of words to be transferred]
PUSH [message time-out value]
PUSH [selection of destination file]
PUSH [word offset within destination file]
PUSH [string number]
POP [CALL 27 status]
Transfer data from a remote DH485 data file to
the SLC processor.
13-8
CALL 28 PUSH [type of WRITE command]
PUSH [remote node address]
PUSH [remote file number]
PUSH [remote file type]
PUSH [remote starting word offset]
PUSH [number of words to be transferred]
PUSH [message time-out value]
PUSH [selection of source file]
PUSH [word offset within source file]
PUSH [string number]
POP [CALL 28 status]
Transfer data from the SLC processor to a
remote DH485 data file.
12-6
CALL 29 PUSH [CALL 27, 28, 122, or 123 for the CALL
you want activated]
POP [status of transaction]
Handle all errors that are not handled by the
ONERR statement.
12-13,
13-13
CALL 30 PUSH [bits per word]
PUSH [parity enable]
PUSH [number of stop bits]
PUSH [software handshaking enable/disable]
PUSH [hardware handshaking enable/disable]
Set PRT2 port parameters. 14-1
CALL 31
None Display current PRT2 port setup. 12-14
CALL 35 POP [ASCII value of character] Get numeric input character from port PRT2. 13-15
CALL 36 PUSH [buffer selection]
POP [number of characters]
Get number of characters in PRT2 buffers. 11-2
CALL 37 PUSH [buffer selection] Clear port PRT2 input and output buffers. 12-15
CALL 38 PUSH [0 or 1] Initiate transactions defined by CALLs 27, 28,
122, and 123.
8-5
Mnemonic Required PUSHes or POPs Description Active In
Command
Mode
Only
Page