Owner's manual

1 Publication 1746-RM001A-US-P

Chapter

Status Functions

This chapter describes and illustrates commands that monitor the status of the

BASIC or BASIC-T module. This chapter also describes and illustrates commands

that allow the setup of the DF1 driver within the BASIC program or from the

command line. Table 11.1 lists the corresponding mnemonics.

Table 11.1 Chapter Reference Guide

If you need to Use this mnemonic Page

Get the number of characters in PRT2 buffers. CALL 36 11-2

Check the CPU output image buffer. CALL 51 11-3

Check the CPU input image buffer. CALL 55 11-4

Check the M0 file status. CALL 58 11-5

Check the M1 file status. CALL 59 11-6

Check the SLC 500 controller CPU status. CALL 75 11-7

Check the battery condition. CALL 80 11-8

Check the DH485 interface file remote Write status. CALL 86 11-8

Check the DH485 interface file remote Read status. CALL 87 11-9

Get the number of characters in the PRT1 buffers. CALL 95 11-10

Enable port PRT2 DTR signal. CALL 97 11-11

Disable port PRT2 DTR signal. CALL 98 11-11

Enable DF1 driver communications. CALL 108 11-12

Disable DF1 driver communications. CALL 113 11-18

Clear the module input and output buffers. CALL 120 11-18

Get the SLC processor program ID number. CALL 121 11-19