Owner's manual

Publication 1746-RM001A-US-P
8-6 Execution Control and Interrupt Support Functions
If you perform an XBY in the error routine, this is a list of the status codes you
might receive.
Table 8.2 Status Codes
Status Code Description
01 module attempted to call an illegal call number
02 port has been assigned an invalid parameter
03 string has not been dimensioned
04 defined string length is too small for operation
05 memory has not been allocated for this string
06 attempted to transfer to a RAM or ROM program that did not exist
07 command or call can only be executed from Command mode
08 user PROM has invalid checksum
09 this statement or call requires a user PROM; no user PROM is installed
10 divide by zero
11 DH485 call executed and DH485 port not enabled
12 argument stack problem
13 syntax error
14 control stack problem
15 array size problem
16 internal processor stack problem
17 no DATA available for READ
18 DF1 cannot be enabled (JW4 in wrong position)
19 • illegal user of PRT2 while DF1 is enabled
• illegal use of PRT2 while background DF1 task is enabled
• attempted to transmit DF1 packet before DF1 is enabled
• attempted to transmit DF1 packet of incorrect length
20 arithmetic overflow (value too large for range)
21 bad line number
22 JW5 in 8-point position
30 arithmetic underflow (value too small for range)
40 bad argument