Instruction Manual

8 1738 ArmorPOINT I/O EtherNet/IP Adapter
Publication 1738-IN031A-EN-P - July 2013
4. Ground the system using the ground lug connection in the adapter’s I/O base.
(The ground lug connection is also a mounting hole).
5. Add one or more I/O modules and their respective I/O mounting bases to the
adapter and its I/O Mounting base as required. See Set the Network Address
on
page 9
for details.
6. Mount the terminating base that was shipped with the adapter as the last base in
the backplane instead of the I/O Mounting base shipped with the I/O module.
ATTENTION: If this equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be impaired.
43787
Mounting hole
Ground lug connection
Keyswitch
Latching
mechanism hole
Terminating Base
Latching mechanism release