Installation Instructions Instruction Manual

POINTBlock dc 8 Input/8 Output Module 5

Publication 1734-IN020A-EN-P - July 2001

Output Wiring

Note: When connecting more than 1 wire in a termination point, make sure

that both wires are the same gauge and type.

Outputs are electronically protected to 0.75A. Module outputs are

selectable for latched mode or auto-reset mode. (Latched/auto reset is set

by module, not by individual channel.) Each channel is assigned a bit in the

data table to indicate the faulted condition. Outputs in the latched mode can

only be reset with a user command to the module.

Output Terminal Common Terminal Power

Remote Termination Block 3

Channel 0 0 4

Channel 1 1 5

Channel 2 2 6

Channel 3 3 7

Remote Termination Block 4

Channel 4 0 4

Channel 5 1 5

Channel 6 2 6

Channel 7 3 7

Module power is supplied from the internal power bus.

Out 0 Out 1

Out 3Out 2

Load Load

42015

Load

V = 12/24V dc, C = Common

Field power is supplied from internal power bus

RTB3 shown