Configuration User Manual

Rockwell Automation Publication ENET-UM001L-EN-P - March 2014 99
Chapter 8
Communicate with PanelView Terminals
This chapter describes how a controller uses an EtherNet/IP communication
module to communicate with PanelView and PanelView Plus terminals over an
EtherNet/IP network.
Set Up the Hardware
In this example, the controller in the local chassis shares data with an HMI
application on the EtherNet/IP network. This application could be running
these components:
• PanelView terminal
• PanelView Plus terminal
• Workstation running Factory Talk View software
• Workstation running a FactoryTalk Enterprise application, such as
FactoryTalk View Machine Edition or FactoryTalk View Supervisory
Edition
Figure 12 - Ethernet Communication with PanelView Terminal
Topic Page
Set Up the Hardware 99
Connections to PanelView Terminals 100
Add a PanelView Terminal 101
Organize Controller Data for a PanelView Terminal 105
Connections to FactoryTalk View Applications 106
Logix5575
Redundancy Module
EtherNet/IP
PRI COM OK
ControlNet
EtherNet/IP
ControlNet
OKFORCESDRUN
R
U
N
R
E
M
P
R
O
G
1 2
LNK1 LNK2 OK
10/100 BASE T
LNK NET OK
EtherNet/IP
LNK NET OK
Local Chassis Containing a
Logix5000 Controller with
an EtherNet/IP Connection
HMI with EtherNet/IP
Connectivity
Data
EtherNet/IP Switch