Instruction Manual

POINT I/O Module with 8 Configurable 24V DC Points 15
Publication
1734-IN038A-EN-P - October 2008
Configure the Module
Read this section for information about how to communicate with your
module.
I/O messages are sent to (consumed) and received from (produced) the
POINT I/O modules. These messages are mapped into the processor’s or
scanner’s memory. Each module produces 1 byte of input data and consumes
1 byte of I/O data (scanner Tx).
In RSLogix5000, the default tag will be AdapterName:SlotNumber:I.Data.
The data type is a SINT.
In RSLogix5000, the default tag will be AdapterName:SlotNumber:O.Data.
The data type is a SINT.
Default Data Map - Produced Assembly Instance 4
Message Size: 1 Byte
76543210
Data Pt 07 Pt 06 Pt 05 Pt 04 Pt 03 Pt 02 Pt 01 Pt 00
Where: Pt = state of the input point
Default Data Map - Consumed Assembly Instance 34
Message Size: 1 Byte
76543210
Data Pt 07 Pt 06 Pt 05 Pt 04 Pt 03 Pt 02 Pt 01 Pt 00
Where: Pt = state of the output point