User Manual Owner manual

68 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 2 Installation Instructions
Mount Termination Assemblies
Termination assemblies connect to I/O base units. You can fit three simplex
assemblies, or one duplex and one simplex assembly. The combination used
depends on your system’s specific configuration requirements.
To connect termination assemblies to I/O base units, follow these steps.
1. Insert the termination assembly (TA) retaining clip on the back of the
termination assembly into the slot on the I/O base unit.
2. Press in and slide the assembly upward as far as it goes until it locks in
place.
32061-M