User Manual Owner manual

198 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
The General tab appears.
See Figure on page 174
for General parameter settings.
3. Click Change, referring to Figure on page 188
for Module Definition
parameter settings.
4. Change Redundant to No to place the module in Simplex mode.
5. Click OK.
The Verify Module Properties dialog box appears. See page 180.
6. Click Yes.
A new General tab appears showing only one slot as available. The module
is now in Simplex mode.