User Manual Owner manual

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 175
Configure the Redundant I/O System Chapter 5
3. Click Change.
The Module Definition dialog box appears.
Table 31 - Module Definition Parameters for Digital Input Module Duplex Mode
Parameters Description
Series Choose the Series of the module.
Only the series supported by the module are displayed.
Revision Major: Choose the Revision of the module.
Minor: Sets the module’s minor revision.
The valid range is 1…255. This field is enabled while offline, and while in the Program, Remote
Program, and Remote Run modes.
For SIL 2 application choose version 3.01.07 or later for 1715 I/O modules.
Electronic Keying Choose the electronic keying you wish to use for the selected module.
Valid values are Compatible Module (default), Exact Match, or Disable Keying. See Appendix B
.
Connection Leave as ‘Data’ - Listen Only is not supported.
Redundant Yes for Duplex mode.
No for Simplex mode.
SIL 2 Safety Choose No if SIL 2 operation is not required.
Choose Yes to enable SIL 2 operation. The safety pulldown appears only if using Add-on Profile version
2.01.007 or later. Two new tabs are available for SIL 2 configuration if you choose Yes. For information on
SIL 2 configuration, see Chapter 6
.