User Manual Owner manual

Rockwell Automation Publication 1715-UM001C-EN-P - March 2014 165
Configure the Redundant I/O System Chapter 5
Table 26 - Module Info A Parameters
Parameters Description
Identification Displays the module’s:
• Vendor
• Product Type
• Product Code
• Revision
• Serial Number
• Product Name
Status
Major/Minor Fault
Major Fault Minor Fault
Displays the fault type Displays the fault type
Internal State Displays the module’s current operational state
Configured Displays a yes or no value indicating whether the module has been configured by an owner controller connected to it - Once a module has been
configured, it stays configured until the module is reset or power is cycled, even if the owner drops connection to the module. This information only
applies to I/O modules and does not apply to adapters, scanners, bridges, or other communication modules.
Owned Displays a yes or no value indicating whether an owner controller is currently connected to the module.
Module Identity Displays If the physical mode is
Match Agrees with what is specified on the General Tab.
For the Match condition to exist, these must agree:
• Vendor
• Module Type (the combination of Product Type and Product Code for a particular
Vendor)
• Major Revision
Mis-match Does not agree with what is specified on the General Tab.
Reset Click Reset to return a module to its power-up state by emulating the cycling of power.
Refresh Module Click Refresh Module to refresh the tab with new data from the module.