User Manual Owner manual

164 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
7. Click the Module Info A Tab.
The Module Info A tab appears.
The Module A Info Tab displays module and status information about the
primary adapter, in slot 0 or 1. (During initial setup, the primary adapter is
installed in slot 0. If an IP address swap occurs, the primary adapter is now in slot
1.)
This tab also lets you reset a module to its power-up state. The information on
this tab is not displayed if you are one of the following:
• Offline
• Currently creating a module