User Manual Owner manual

150 Rockwell Automation Publication 1715-UM001C-EN-P - March 2014
Chapter 5 Configure the Redundant I/O System
Install the Software
Install the following software:
• RSLogix 5000 programming software, version 19 or later, or Studio 5000
environment, version 21 or later
• RSLinx Classic software, version 2.57 or later
Install the Add-on Profiles
You need to install two Add-on Profiles — one for the adapter modules, version
2.01.014 or later, and one for each of the I/O modules, version 3.01.014 or later.
(The four I/O module Add-on Profiles are contained in one file.)
See the latest certifications for software and firmware at
http://www.rockwellautomation.com
. See the TÜV website at
http://www.tuvasi.com
for SIL 2 certification listings.
The Add-on Profiles can be found in one of two ways:
• On the disk that came with your system
• On the Product Compatibility and Download Center
website
• Once the Add-on Profiles are installed on your computer, they can be
accessed through RSLogix 5000 software and/or the Logix Designer
application.
With the Add-on Profiles, you are able to do the following:
• Add and configure the redundant adapter pair.
• Add and configure I/O modules in Simplex mode.
• Add and configure I/O modules in Duplex mode.
• Monitor diagnostics for I/O modules.
To install the Add-on Profiles, follow these steps.
If Installing from the CD
1. Insert the CD that was shipped with your module into your computer.
2. Follow the prompts to complete the installation.
If Installing from the Product Compatibility and Download Center
Website
To download the Add-on Profiles for the 1715 adapters and I/O modules, follow
these steps.
1. Go to the Product Compatibility and Download Center website.
IMPORTANT
Make sure any instances of RSLogix 5000 programming software or Logix
Designer application are shut down before beginning.