User Manual, 100/110 A Manual
Rockwell Automation Publication 1608P-IN002B-EN-P - May 2014 13
Installation Chapter 2
Electrical Terminations and
Ratings
Input terminal blocks are marked L1, L2, and L3 for the source connections.
Output terminal blocks are marked X1, X2, and X3 for the load connections (See
Figure 7
). In 4-wire models only, connect both input and output N conductors to
the NEUTRAL bus bar. Do not connect to the NEUTRAL bus bar in 3-wire
models. The door must be closed and latched securely when the wiring is
completed.
Figure 7 - Electrical Terminations and Ratings
WARNING: The ProDySC must be safety-grounded according to the National
Code. In addition, all local, state, and federal regulations applicable to the
installation of electrical systems as well as accident prevention regulations
must be strictly observed