User Manual, 800 - 2400 A User guide

Rockwell Automation Publication 1608M-UM002A-EN-P - September 2013 25
Chapter 6
Display Screen
Overview
The MegaDySC touch screen display is a window to voltage sags and DySC
protection. The display provides system status, voltage sag notification and
history, runtime statistics and system history in a simple and intuitive touch-
based user interface.
Quick Start
At commissioning time perform the following steps to configure your system.
Note: The touch screen is optimized for use with a plastic stylus or bare finger.
When the system first starts, the “HOME” screen is displayed.
Step 1:Press the “Configuration” button at the top of the screen (See Figure 8
).
Figure 8 - Quick Start
Step 2:Set date and time by pressing “Set System Clock” on the left side of the
screen (See Figure 8
).
Step 3:Use the left/right arrows under “System Clock” to highlight each
component. Use the plus (+) and minus (-) buttons to set the correct time and/or
date.