Installation Instructions 400 A

20 Rockwell Automation Publication 1608M-IN001A-EN-P - September 2013
Chapter 3 Communications
i-Sense Voltage Monitor
Communications
The i-Sense voltage monitor is located on the bottom front of the bypass
switchboard and is pre-wired to monitor the MegaDySC input and output
voltages. The i-Sense Ethernet and Modem communications ports are internally
connected to the RJ45 and RJ11 jacks, respectively, located in the upper
compartment of the bypass switchboard. See Figure 6
and Figure 9 for conduit
entry locations. A communications connection is required to enable i-Sense
monitoring. See publication 1608S-UM001A-EN-P for more information.
Figure 9 - Communications Conduit Entrance view from within upper switchboard compartment
Conduit
Entry for
optional TB1
i-Sense
communications
jacks (access from
above)
Conduit Entry for
i-Sense
communications
TB1