Manual

13 Publication GMSI10-UM015B-EN-E - June 2011
Chapter 2
Installing the XM Electronic Overspeed
Detection System
This chapter discusses how to install and wire the XM Electronic Overspeed
Detection System. It also describes the LED indicators and the basic operation
of the XM EODS.
For information about See page
XM Installation Requirements 14
Mounting the Power Supply Modules 19
Mounting the Terminal Base Units 20
Connecting Wiring for Your XM EODS 24
Mounting the XM Modules 39
LED Indicators 41
Basic Operations 44
ATTENTION
Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2
Industrial environment, in overvoltage Category II applications
(as defined in IED publication 60664–1), at altitudes up to 2000
meters without derating.
This equipment is supplied as “open type” equipment. It must be
mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present, and
appropriately designed to prevent personal injury resulting from
accessibility to live parts. The interior of the enclosure must be
accessible only by the use of a tool. Subsequent sections of this
publication may contain additional information regarding specific
enclosure type ratings that are required to comply with certain
product safety certifications.
See NEMA Standards publication 250 and IEC publication
60529, as applicable, for explanations of the degrees of
protection provided by different types of enclosures.