Manual

Publication 0160-5.5 - September 1997

P-4 Using This Manual

Safety Precautions (Continued)

DeviceNet Compatibility

The 160-DN1 Communication Module is intended for use only with

Bulletin 160 SSC devices. When properly connected, the Communi-

cation Module communicates via the DeviceNet Protocol. The Com-

munication Module/Bulletin 160 SSC combination comprise a

Group 2 Slave Only device. This device supports DeviceNet slave

Polled, Change of State/Cyclic messaging, and DeviceNet slave

Explicit messaging.

ATTENTION: The drive contains high voltage

capacitors which take time to discharge after removal

of mains supply. Before installing or removing the

DeviceNetCommunicationModule,ensureisolation of

mains supply from line inputs [L1, L2, L3 (R, S, T)].

Wait one minute for capacitors to discharge to safe

voltage levels. Failure to do so may result in personal

injury or death.

ATTENTION: When a system is conﬁgured for the

ﬁrst time, the motor must be disconnected from the

machineorprocessduringinitial systemtesting.Hazard

of injury or equipment damage may occur due to

unintended or incorrect machine motion.