Manual
80 Rockwell Automation Publication 1500-UM055G-EN-P - May 2013
Appendix B ArcShield Plenum Installation Instructions
Cabinet Preparation
In preparation for mounting Plenum, remove 1/4-20 fasteners from the Relief
vent on the top of the MV enclosure. Leave the (4) corner fasteners in place
(see
Figure 79
).
The Plenums are designed to fit over the fastener heads at the (4) corners of the
Relief vent. The corner fasteners are required to secure the Relief vent during
installation.
Plenum Placement on Structure
Once the Plenum has been lifted in place directly over the relief vent (shown in
Figure 80
), all 1/4-20 fasteners, removed in Cabinet Preparation above, are
replaced to attach the Plenum to the top of the enclosure. Use hand tools only.
Figure 78 - Relief Vent Fasteners (top view) Figure 79 - Relief Vent
Relief vent
Relief fasteners
Corner fasteners