Manual

12 Rockwell Automation Publication 1500-UM055G-EN-P - May 2013
Chapter 2 Installation – Standard Enclosure
3. Open the low voltage cell doors (refer to Opening the Low Voltage Doors
on page 5).
4. Disconnect the control wiring harness from the wire plug at the lower left
side of the contactor.
5. Remove the two self-tapping screws from the center vertical channel (see
Figure 10
).
6. Pull on the center vertical channel to swing out the low voltage panel.
Figure 10 - Center Vertical Channel
Remove self-tapping screws
from center vertical channel
Control Wiring Harness