Manual

Rockwell Automation Publication 1512A-UM100F-EN-P - May 2013 3
Chapter 2
Installation – Standard Enclosure
Door Opening Procedure
Opening the Low Voltage Doors
Low voltage doors are identified as LV in Figure 3.
1. To access the low voltage compartment, use a flat-head screwdriver and
turn both of the 1/4-turn fasteners, located on the low voltage door, 90° in
a counterclockwise direction.
2. The door is now released and will swing open.
3. Reverse the procedure to secure the doors.
Figure 3 - Standard Cabinet
Refer to Access to the Power Bus on page 7 for the procedure to open the swing-
out low voltage panel behind the low voltage door.
IMPORTANT
For information on the installation site preparation, see Publication
MV-QS050_-EN-P
.
ATTENTION: Use suitable personal protective equipment (PPE) per local codes
or regulations. Failure to do so may result in severe burns, injury or death.
.
.
.
.
Low Voltage Door
Medium Voltage Door