Manual

9-20 DeviceLogix
1503-UM054C-EN-P – June 2013
Figure 9.10 – Timing Diagram for the Up/Down Counter with a Preset Value = 3
Table 9.H – Up/Down Counter Valid Data Ranges
Parameters Data Range
PRE
0 ~ 65535
ACC
0 ~ 65535
Offline Operations
Once configured the IntelliVAC Plus can operate without a network
and perform local control functions. When a network is not used,
enable the Comm. Status Override Parameter on the Device
Parameters Tab. This will override any errors that are generated
because there is no network. If this parameter is not enabled, the
Outputs will not react to the local logic.
Online Operations
You can perform the following functions when you work Online:
• Communicate with devices
• View the status of I/O with online animation
• Change Logic
• Change the value of timers and counters
• Enable and disable logic
• Verify logic
• Compare logic
• Upload old logic from device to editor
• Download new logic from editor to device
• Force