User Manual

Installation

Overview This chapter describes the procedures for the installation of the GE Multilin to

Bulletin 825 Plus Conversion Kit within a medium voltage controller.

Installation within other controller types can also be accomplished by following

the principal philosophy of the retrot described.

This manual is intended for use by personnel trained and

familiar with medium voltage, solid-state power equipment,

and general industrial controls.

Pre-Installation To avoid shock hazards, lock out incoming power before

working on the equipment. Verify with a hot stick or appro-

priate voltage measuring device that all circuits are voltage

free. Failure to do so may result in severe burns, injury or

death.

The National Electrical Code (NEC) and/or Canadian Elec-

trical Code (CEC) or other local codes outline provisions

for safely installing electrical equipment Failure to follow

locally applicable codes can result in hazards to personnel

or a non-compliant installation.

Tools required:

• Sheet metal cutting tools capable of cutting up to 12 gauge material

• Hand drill, and drill bits

•

Screw drivers / Nut drivers

• Drop sheets or tarp

• Socket wrench with 3/8 socket

• Marking device

• Needle nose pliers

• Wire cutters

Chapter 4

1500-IN059C-EN-E – June 2013

Figure 4.1 – Tools Required

ATTENTION

IMPORTAN T

ATTENTION