Owner's manual

1500-IN058D-EN-E – June 2013

1-2 Introduction

The elimination of a disturbance may cause the motor to

start running again by itself. This may endanger persons

or damage equipment. The user must take the necessary

safety measures to protect against this type of occurrence

so that any danger is avoided.

Kit Highlights and Limitations The Bulletin 1406 to Bulletin 825 Plus Conversion Kit provides most of

the features and functionality of the Bulletin 1406. However, the

Conversion Kit also provides additional features and functions not

provided/supported by the Bulletin 1406.

The Bulletin 825 Plus Conversion Kit provides:

• easy installation

• modular design

• no additional wiring

• uses existing low voltage door and panels (in most cases)

• various communication methods:

– DeviceNet

– Modbus

• (12) RTD inputs with remote RTD Scanner (optional)

• programmable analog output

X Option card required.

Y Does not support interconnection method used by the Bulletin 1406-P and 1406-AA.

Note: The user must validate the control and protection capabilities

of the 825 Plus.

Personnel Safety Protection of personnel in the vicinity of control equipment is of primary

importance. The corresponding requirements of regulatory agencies are

therefore becoming increasingly severe. The Bulletin 825 Plus reflects this

by providing the following protection:

• Equipment construction: – Touch protection

– Insulated housing

• Motor protective functions: – Earth (ground) fault

– High overload, stalling and jam

– Phase reversal

Overview (cont.)

A T T E N T I O NA T T E N T I O N