Owner's manual

1500-IN058D-EN-E – June 2013
4-8 Installation
Wiring the Control Circuit
1. Reconnect the control wires to the corresponding 825 Plus Interface
Panel terminal blocks. These are located and numbered the same as
those on the 1406-P16. Use the wire number table (created as part of
the procedures on page 4-2) in Appendix A, to verify the wire
numbers and the terminal block location. (Figures 4.20 and 4.21)
2. Using the provided spiral wrap, combine the existing and new door
control wire bundles. (Figure 4.22)
Figure 4.20
Figure 4.21
Figure 4.22