Installation Instructions (30A, 60A, 100A) Owner manual

(7)

PN-224754

DIR 10001182729 (Version 01)

Cable Adjustment Procedure

1 Move handle to “ON” position. 2 Remove cable pivot hitch pin and washer. 3 Push cable pivot out of handle bracket.

4 Return handle to “OFF” position. 5 (a) ADJUSTMENT PROCEDURE IF

SWITCH DOES NOT FULLY CLOSE

Unscrew cable pivot ONE full turn

counter-clockwise to extend cable.

6 Return handle to “ON” position and insert

cable pivot back into mechanism.

7 Re-install cable pivot washer and hitch pin. 8 Confirm switch operates properly and

repeat steps 5-7 if necessary.

(b) ADJUSTMENT PROCEDURE IF

SWITCH DOES NOT FULLY OPEN

Turn cable pivot ONE full turn

clockwise to shorten cable.