Installation Instructions (30A, 60A, 100A) Owner manual

(14)
PN-224754
DIR 10001182729 (Version 01)
Protective Cover Installation
1 Position cover in front of switch as shown. 2 Spread sides apart at bottom to fit around fuse block.
3 Rotate cover up and slide top sides into tracks shown on switch.
Push in until fully inserted and pull cover down slightly to ensure
engagement.
4 Press center of cover tight to mounting plate to engage notch in right
side of cover with switch bracket.
5 Ensure flange on left side of cover has snapped under fuse block.
6 Optional: Install high-vibration application screw in bottom slot.