User Manual User Manual

Rockwell Automation Publication 1492-UM008A-EN-P - June 2010 5-7
Calibration Chapter 5
Figure 5.12 -
Figure 5.13 -
Notes: -When making adjustments use maximum increments of 0.5mm.
To enter a negative value, add a dash "-" before the desired number
Adjusting Width/Height of Cards
Note: Only complete these steps if you are not satisfied with calibrating the
offset values
7. To determine if the width or height of a card needs to be adjusted, place a
capital "X" in all of the far left, bottom, and far right tags.
8. Print the test card
9. If the width is not set correctly, the text will slowly drift out of alignment
from left to right (See Figure 5.14).
If “X” appears
on this half of
the card
increase the
“Offset X (a)” value
to move it back
to center.
If “X” appears
on this half of
the card
decrease the
“Offset X (a)” value
to move it back
to center.
If “X” appears on this half of
the card increase the “Offset Y (b)” value
to move it back to center.
If “X” appears on this half of
the card decrease the “Offset Y (b)” value
to move it back to center.