User Manual User Manual

5-4 Rockwell Automation Publication 1492-UM008A-EN-P - June 2010

Chapter 5 Calibration

19. Place a capital "X" in the upper right corner as shown( See Figure 5.6 ).

You can leave the "X" in the first column because it will not move with

these upcoming changes.

20. Go to File→Print, and click [Print].

Figure 5.6 -

21. If the "X" is centered you are done calibrating and are ready to print. (See

section on printing).

22. If the "X" is not centered. Go to File→ Set Printer Correction. ( See

Figure 5.7).

Figure 5.7 -