User Manual User Manual

Rockwell Automation Publication 1492-UM008A-EN-P - June 2010 5-3
Calibration Chapter 5
18. After making a change, Click [Save]. Then click [Print] to check the card.
a. If centered go to step 19, If not go back to step 15.
Figure 5.4 -
Figure 5.5 -
If “X” appears
on this half of
the card
increase the
“Left” number
to move it back
to center.
If “X” appears
on this half of
the card
decrease the
“Left” number
to move it back
to center.
If “X” appears on this half of
the card increase the “Top” number
to move it back to center.
If “X” appears on this half of
the card decrease the “Top” number
to move it back to center.