Manual

26 Rockwell Automation Publication ICM-UM004C-EN-E - February 2014
Chapter 1 Installation
Mount the Driver to a DIN Rail
The driver can be mounted to a 35 mm DIN rail.
1. Hook the upper tabs on the back of the driver onto the DIN rail.
2. Push the driver into the DIN rail until a click is heard from the slide lock.
If the driver does not fit onto the DIN rail well, pull on the slide lock and
push the driver against the DIN rail.
3. Make sure the upper tabs and the slide lock are securely fixed on the DIN
rail.
Install the Sensor
Install according to the conditions described in the Sensor Installation
Environment on page 13.
TIP
Remove the driver by pushing down on the slide lock with a flat-blade
screwdriver.
ATTENTION: Do not drop or otherwise subject the sensor to shock.
TIP
The sensor installation instructions comply with API Standard 670.