Owner manual

Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012 281
Run Up/Coast Down Application Chapter 10
Recalling a Setup
You can recall a previously saved setup and use it to collect another measurement.
The setup may have been saved only as a setup, or may have been saved with the
recorded data.
Refer to
Saving Run Up/Coast Down Measurements on page 279.
1. Select RUCD on the Main Menu and press the READ/OK key.
The RUCD screen appears.
2. Select Recall and press the READ/OK key.
The RUCD - Load Setup screen appears.
3. Highlight the filename that you want recall and press F4 (Open).
The RUCD - Setup screen appears.
4. You can edit the settings or start collecting data.
For information on editing the settings, see Setting Up Run Up/Coast
Down Measurements on page 257.
For information on collecting RUCD measurements, see Collecting Run
Up/Coast Down Measurements on page 259.