Owner's manual

49 Publication GMSI10-UM003D-EN-P - May 2010
Chapter 3
Configuration Parameters
This chapter provides a complete listing and description of the XM-123
parameters. The parameters can be viewed and edited using the XM Serial
Configuration Utility software and a personal computer. If the module is
installed on a DeviceNet network, configuring can also be performed using a
network configuration tool such as RSNetWorx (Version 3.0 or later). Refer to
your configuration tool documentation for instructions on configuring a
device.
For information about See page
Channel Transducer Parameters 50
Channel Signal Processing Parameters 52
Overall Measurement Parameters 53
Aeroderivative Measurement Parameter 55
Tracking Measurement Parameters 55
Bandpass Measurement Parameters 56
Tachometer Parameters 57
Alarm Parameters 60
Relay Parameters 64
4-20 mA Output Parameters 68
Triggered Trend Parameters 69
SU/CD Trend Parameters 71
I/O Data Parameters 74
Data Parameters 76
Device Mode Parameters 79
IMPORTANT
The
The appearance and procedure to configure the parameters
may differ in different software.