Owner's manual

Publication GMSI10-UM003D-EN-P - May 2010
155
I/O message formats
bit-strobe messages
96
change of state (COS) messages 95
poll messages 93
XM status values 95
Identity Object 100
indicators 45
Channel Status 47
Module Status 46
Network Status 46
Relay 47
Setpoint Multiplier 47
Tachometer Status 47
installation requirements
grounding
8
power 6
wiring 6
interconnecting terminal base units 15
introduction 1
invalid device configuration errors 92
K
keyswitch 44
M
Module Status (MS) indicator 46
mounting
terminal base unit on DIN rail
13
terminal base unit on panel/walll 16
XM-123 module on terminal base 44
N
Network Status (NS) indicator 46
node address 43
normally closed relay contacts 21
normally open relay contacts 21
O
operating mode
program mode
46, 89
run mode 46, 89
Overall Measurement Object 129
overall measurement parameters 53
Low Pass Filter 54
Overall Damping Factor 54
Overall Filter 54
Overall Time Constant 54
Signal Detection 53
P
panel/wall mount grounding requirements 10
Parameter Object 110
poll message format 93
Assembly instance 101 94
Assembly instance 102 94
power requirements 6
power supply, wiring 20
program mode 46, 89
R
relay contacts
normally closed
21
normally open 21
Relay indicator 47
Relay Object 132
relay parameters 64
Activation Delay 65
Activation Logic 65
Alarm A 65
Alarm B 65
Alarm Identifier A 65
Alarm Identifier B 65
Alarm Levels 66
Alarm Status to Activate On (Alarm Levels) 66
Enable 65
Failsafe 67
Latching 65
Name 64
Number 64
Relay Installed 66
relays
resetting
38, 48
wiring 21
remote relay reset signal, wiring 38
reset switch 48
run mode 46, 89
S
self-test, status 47
serial port connection
terminal base unit
41
USB-style connector 42
setpoint multiplication switch, wiring 39
Setpoint Multiplier indicator 47