Owner's manual

Publication GMSI10-UM003D-EN-P - May 2010
139
Vector Measurement
Object
(Class ID 329
H
)
The Vector Measurement Object models the measurement of the amplitude
and phase of the input signal at a specific multiple of the machine speed.
Class Attributes
The Vector Measurement Object provides no class attributes.
Instances
There are 2 instances of this object.
Instance Attributes
Table C.50 Vector Measurement Object Instances
Instance Description
1 Channel 1 Tracking Measurement
2 Channel 2 Tracking Measurement
Table C.51 Vector Measurement Object Instance Attributes
Attr ID
Access
Rule Name Data Type Description Semantics
3 Get Magnitude
Value
REAL The measured magnitude
value.
4 Get Phase Value REAL The measured phase
value.
Degrees
5 Get Status BOOL Indicates if a fault or
alarm has occurred.
0 = Operating without alarms of
faults.
1 = Alarm or fault condition
exists. The Value attributes
may not represent the actual
field value.
6 Get Magnitude Data
Units
ENGUNIT The units context of the
Magnitude Value
attribute.
This setting is determined by the
Channel Object’s Output Data
Units setting (see page 125).
7 Get/Set Speed Value REAL The speed at which the
magnitude and phase are
measured.
A multiple of the measured
machine speed
0.1 ≥ speed multiple ≤ 20
8 Get Speed Data
Units
ENGUNIT The units context of the
Speed Value attribute.
See DeviceNet Specification
Volume 1 Appendix K.
This is set to Orders (0x0B00).