Instruction Manual

Publication GMSI10-UM005C-EN-P - May 2010
DeviceNet Information 79
Bit-Strobe Message Format
The Bit-Strobe command sends one bit of output data to each XM slave
whose node address appears in the master’s scanlist.
The Bit-Strobe command message contains a bit string of 64 bits (8 bytes) of
output data, one output bit per node address on the network. One bit is
assigned to each node address supported on the network (0...63) as shown in
Figure B.1.
Figure B.1 Bit-Strobe Command
5 Module Fault
6 Tachometer Fault
7 Reserved
Setpoint Multiplier Status Descriptions
Setpoint Multiplier Status Value Description
0 Not Activated
1 Activated
Relay Status Descriptions
Relay Status Value Description
0Not Activated
1Activated
Alarm Status Descriptions
Alarm Status Value Description