Instruction Manual

45 Publication GMSI10-UM005C-EN-P - May 2010
Chapter 3
Configuration Parameters
This chapter provides a complete listing and description of the XM-320
parameters. The parameters can be viewed and edited using the XM Serial
Configuration Utility software and a personal computer. If the module is
installed on a DeviceNet network, configuring can also be performed using a
network configuration tool such as RSNetWorx (Version 3.0 or later). Refer to
your configuration tool documentation for instructions on configuring a
device.
For information about See page
Channel Parameters 46
Measurement Mode Parameter 49
Alarm Parameters 55
Relay Parameters 58
4-20mA Output Parameters 62
Triggered Trend Parameters 63
I/O Data Parameters 65
Data Parameters 66
Device Mode Parameters 68
IMPORTANT
The appearance and procedure to configure the parameters
may differ in different software.