Owner manual

43 Publication GMSI10-UM006C-EN-P - August 2010
Chapter 3
Configuration Parameters
This chapter provides a complete listing and description of the XM-360
parameters. The parameters can be viewed and edited using the XM Serial
Configuration Utility software and a personal computer. If the module is
installed on a DeviceNet network, configuring can also be performed using a
network configuration tool such as RSNetWorx (Version 3.0 or later). Refer to
your configuration tool documentation for instructions on configuring a
device.
For information about See page
General Parameters 44
Channel Parameters 44
Alarm Parameters 46
Relay Parameters 49
4-20mA Output Parameters 53
Triggered Trend Parameters 54
I/O Data Parameters 57
Data Parameters 58
Device Mode Parameters 60
IMPORTANT
The
The appearance and procedure to configure the parameters
may differ in different software.