Owner's manual

10 XM ControlNet Adapter
Publication
ICM-IN001A-EN-P - March 2009
Wire the ControlNet Adapter
1. Connect the ControlNet network cable to connector A.
WARNING
If you connect or disconnect wiring while the field-side power is on, an
electrical arc can occur. This could cause an explosion in hazardous location
installations. Be sure that power is removed or the area is nonhazardous
before proceeding.
WARNING
If you connect or disconnect the communications cable with power applied to
this module or any device on the network, an electrical arc can occur. This
could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
ATTENTION
Do not wire more than two conductors on any single terminal.
ControlNet XM Adapter
2
5
1440-ACNR
AB
A
BG
CE
DF