Manual

40 Rockwell Automation Publication 1426-UM001F-EN-P - November 2013
Chapter 2 Install the PowerMonitor 5000 Unit
Optional ControlNet Communications
An optional ControlNet port can be factory-installed in PowerMonitor 5000
units with a catalog number ending in -CNT, and can also be purchased from
Rockwell Automation and installed by the user.
For information on installing the optional communication card, see the
PowerMonitor 5000 Optional Communication Modules Installation
Instructions, publication 1426-IN002
.
A ControlNet media installation includes trunk cable, taps and terminators, and
can include optional redundant media. For detailed ControlNet system
installation information, refer to the ControlNet Coax Media Planning and
Installation Guide, publication CNET-IN002
, and the ControlNet Network
Configuration User Manual, publication CNET-UM001
.
This diagram shows a simple ControlNet network installation using redundant
media.
ATTENTION: Power must be removed from the power monitor before inserting
or removing an optional communication card. Inserting or removing an
optional communication card under power may damage the card or the power
monitor.
Virtual Wiring
Correction
---- S1
S2
---- S3
S4
---- S com
S com
---- K
Y
---- Z
R1 O
---- R1 com
R1 C
---- R2 O
R2 com
---- R2 C
R3 O
---- R3 com
R3 C
Module
status
Network
status
Cong Lock
EtherNet √
IP
PowerMonitor 5000
Power
USB
Device
USB
Host
LNK
ACT
I 1
I 2
I 3
I 4
L1
L2
GND
24V
com
Scom
S n
Internal
24 VDC
K
Y
Z
Rx O
Rx com Rx C
V1
V2
V3
VN
VG
AB
ControlNet
MS