Installation Instructions Owner manual

14 Rockwell Automation Publication 1426-IN004A-EN-P - December 2013
PowerMonitor 5000 Unit Firmware Revision Update
• If there is a DeviceNet communication card in the card slot, the
PowerMonitor 5000 unit has the catalog number format 1426-MxE-DNT.
Option 2: View the PowerMonitor 5000 Webpage
The PowerMonitor 5000 webpage can be accessed in the following ways:
• Ethernet: If the PowerMonitor 5000 unit is able to communicate through
an Ethernet network, search for the device’s IP address in an Internet web
browser. The catalog number and installed communication type are listed
on the home page as shown in Figure 1
.
• USB: If the PowerMonitor 5000 unit is connected with a USB cable, search
for the default device’s IP address 192.168.169.3 in an Internet web
browser. The catalog number and installed communication type are listed
on the home page as shown in Figure 1
.
TIP
To access the device’s webpage through a USB cable, an RNDIS driver must be
installed on the computer. Refer to the PowerMonitor 5000 USV Driver Installation
and Configuration Installation Instructions, publication
1426
-IN001, for directions
on installing the driver.
TIP
If a field-installed optional communication card is added to the device, the
webpage does not reflect the change in communication card information. In
this case, use the Option 1: V
isual Inspection method.
DeviceNet network
communication card present.