Installation Instructions Owner manual

10 Rockwell Automation Publication 1426-IN004A-EN-P - December 2013
PowerMonitor 5000 Unit Firmware Revision Update
6. In RSLinx software, navigate to the IP address of the device over the
Ethernet network, select the device, and click OK.
To update the firmware revision over the ControlNet or DeviceNet
network, navigate to the device through the network scanner in the RSLinx
software window.
To update the firmware revision via a USB connection, an RNDIS driver
must be installed. Refer to the PowerMonitor 5000 USB Driver
Installation and Configuration Installation Instructions, publication
1426-IN001,
for directions on installing the driver.
TIP
RSLinx Classic Lite software must be installed to continue with the upgrade
process.
TIP
To access the device IP address, the IP address must be added to the Ethernet
device’s driver address list in RSLinx software.