Software Tutorial Instruction Manual

13
Now select again [ Specifi c components ], then select “Add New Dataset” and add two CC
fuses, 3 A. Enter the parameters as shown in the picture below and select the [ OK ] button.
 e newly added components appear at the end of the components table. Now enter the
quantities and the operating current as shown in the next picture.
 e transformer is considered to run at constant power loss, so the Operating Current is
not required.
Because we considered constant power loss and a Service Factor of 100 %, we do not apply a
Reduction Factor to the transformer and its supply circuit.
2.3.2
Add Additional
Components
(continued)