Owner manual

ManualsBrandsRockwell Automation ManualsEquipment1414-ITExxxxx_CTExxxxx Strap-on Temperature Transmitter

Publication 1414-IN013A-EN-P - October 2005

Installation Instructions

Strap-on Temperature Transmitter

Catalog Number(s) 1414-ITE03ADSAA,

1414-ITE03ACSAA, 1414-ITE02ADSAA,

1414-ITE02ACSAA, 1414-CTE03PDSAA,

1414-CTE03PCSAA, 1414-CTE03PASAA

About the Strap-on Temperature Transmitter

Designed for monitoring temperatures on pipes where an immersion sensor can

not be used. It is available with various enclosures to fit any application

Summary of content (4 pages)

PAGE 1
Installation Instructions Strap-on Temperature Transmitter Catalog Number(s) 1414-ITE03ADSAA, 1414-ITE03ACSAA, 1414-ITE02ADSAA, 1414-ITE02ACSAA, 1414-CTE03PDSAA, 1414-CTE03PCSAA, 1414-CTE03PASAA About the Strap-on Temperature Transmitter Designed for monitoring temperatures on pipes where an immersion sensor can not be used.
PAGE 2
Strap-on Temperature Transmitter Important User Information Solid state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (Publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://www.literature.rockwellautomation.com) describes some important differences between solid state equipment and hard-wired electromechanical devices.
PAGE 3
Strap-on Temperature Transmitter 3 Install the Strap-on Temperature Probe Mount the probe under any pipe insulation in direct contact with the pipe to measure the temperature of the pipe using metal pipe straps or cable ties. For best results, thermal compound should be used between the probe and pipe to improve heat transfer and the installation should be wrapped with insulation to reduce the effects of ambient air.
PAGE 4
TIP If the unit uses a three-wire sensor, a jumper must be placed between EXC and SEN. 2. Adjust the ZERO pot until the desired output is achieved. 3. Connect the resistor that represents the span value to the EXC and NEG terminals. 4. Adjust the SPAN pot until the desired output is achieved. Repeat these steps until no further adjustment is required.